How to Redo a Brick Path | Ask This Old House
In this video, This Old House Mason Mark McCullough helps a homeowner redo his brick walkway that was originally a rush job. He explains that walkways need a sturdy, consistent base so it is not a project to be rushed.
SUBSCRIBE to This Old House: http://bit.ly/SubscribeThisOldHouse.
Mark and the homeowner tear up the old bricks and save as many as they can to reuse later on. Mark explains that every good walkway uses three ingredients: crusher run, stone dust, and a good edging. Not compacting the base enough can also cause bumps in a walkway, and a simple plastic edging to both sides of the walkway will ensure that the walkway is held in place.
Time: 6 – 12 hours
Cost: $800+
Skill Level: Difficult
Tools:
Pickaxe [https://amzn.to/3njjpe4]
Rake [https://amzn.to/3pU8ER1]
Shovel [https://amzn.to/397jlZB]
Compactor [http://thd.co/3nmgvoA]
Mallet [https://amzn.to/2XefvZk]
Broom [https://amzn.to/38l4cVB]
Hose [https://amzn.to/3nkWT4y]
Shopping List:
Bricks [http://bit.ly/2Xk3EsJ]
Crusher run [http://thd.co/39bVwQm]
Stone dust [http://thd.co/2Lp9UNc]
Edging [https://amzn.to/39aFYwb]
Steps:
1. Remove old bricks. Saving any bricks in good condition to use for the new path.
2. Use a rake to loosen up any crushed stone and stone dust that was sitting under the brick. You’ll want to get to the very base of the pathway. Use a shovel to put the excess to the side. In general, Mark likes to dig a 6-8” trench.
3. Compact the soil to make sure it’s even and firm. Compacting can be the most time-consuming part of the job, renting a compactor from any home center can make it easier. When the layers are not compacted enough, it can result in an uneven walkway.
4. Shovel the old crushed stone back in and/or add new crusher run if needed. Mark likes to use 3” of crushed stone, which allows for water drainage and helps mitigate any freeze/thaw conditions that will move the walkway.
5. Compact.
6. Add in the stone dust. This top layer will smooth out the crushed stone and gives a flat surface to place the bricks on.
7. Compact. Spraying water right before compacting can keep the dust down.
8. Lay the bricks down. Mark choosed to install the bricks end-to-end instead of side-to-side like the homeowner had. Mark’s way is usually more pleasing to the eye and there are less cuts to make this way.
9. Install the plastic edging. Line it up against the brick and nail it down.
10. Sweep the stone dust into the joints. This will solidify the brick walkway and keep the weeds away.
11. Rinse the stone dust on top of the pavers using the lightest possible setting on the hose.
12. The rinse will sink the stone dust deeper into the cracks, so there will be gaps visible again. After the walkway dries, spread another coat of stone dust and sweep it into the cracks and the walkway should now be tight and solid.
To finish it off, Mark and the homeowner brush stone dust in between each joint to solidify the brick walkway and keep the weeds away.
Where to find it?
The homeowner’s original bricks were McAvoy Pavers [http://bit.ly/2Xk3EsJ], which can be found at brickyards. Mark reused as many of the homeowner’s bricks and mixed in the new ones along the walkway so they would blend in.
To keep the walkway together and help prevent weeds, Mark also installed No-Dig Landscape Edging, which is manufactured by Vigoro and available at most home centers.
Looking for more step by step guidance on how to complete projects around the house? Join This Old House Insider to stream over 1,000 episodes commercial-free: https://bit.ly/2GPiYbH
Plus, download our FREE app for full-episode streaming to your connected TV, phone or tablet: https://www.thisoldhouse.com/pages/streaming-app
About Ask This Old House TV:
From the makers of This Old House, America’s first and most trusted home improvement show, Ask This Old House answers the steady stream of home improvement questions asked by viewers across the United States. Covering topics from landscaping to electrical to HVAC and plumbing to painting and more. Ask This Old House features the experts from This Old House, including general contractor Tom Silva, plumbing and heating expert Richard Trethewey, landscape contractor Jenn Nawada, master carpenter Norm Abram, and host Kevin O’Connor. Ask This Old House helps you protect and preserve your greatest investment—your home.
Follow This Old House and Ask This Old House:
Facebook: http://bit.ly/ThisOldHouseFB
Twitter: http://bit.ly/AskTOHTwitter
Pinterest: http://bit.ly/ThisOldHousePinterest
Instagram: http://bit.ly/AskTOHIG
How to Redo a Brick Path | Ask This Old House
https://www.youtube.com/user/thisoldhouse/
About The Author
You Might Be Interested In
Comment (0)
LEAVE YOUR COMMENT
You must be logged in to post a comment.
Hit me with a heart
That is a good looking walkway good job.
Mark: not afraid to get dirty.
Laying that sharp edge brick with no gloves? Not for me. My hands would be hamburger after that.
Great cinematography. If only TOH circa 1979 WGBH Boston could dream!
Gold Rush: Dave Turin’s Lost Mind
Will look the same as before after two winters. Far too little gravel substructure. Has to be at least 30-40cm.
Then why do most of the contractors just put down sand under the brick
Brick house
Folks always blaming stuff on their children.
That's a very lazy way to make a walk way.
Homeowner had an insane amount of cuts in that first walkway. I heard you need at least a 7” base.
Still looks bad
Ugly pavement
The brick suppose to lay length wise not across to achieve the curve without cut it in pieces
Where is the polymeric sand that Roger's so found about??
It’s like he’s scolding him lol
My wife slipped in Icelan-
Uh-Oooh!!
moves on
I see the cameraman was excited to try out some new equipment
These videos are the best. Thank you for such great content!!!
I'm tackling my old brick walkway. This video shows me exactly what to do to get my project done properly. Thank you for sharing your expertise and wisdom.
love it ! thank you guys!!!!!!!!!!!
lol, stack them not pile them.
man I would want to work for Mark…so much to learn
No cuts in the curve.. how do you now the degree / arc you can do and not have to cut?
I never use plastic edging, metal only!
How do you deal with chipmunks that burrow from beneath?