diy Metal And Wood Entry Gate
this old house needed a new gate!
GET TOOLS AND PLANS DELIVERED IN TWO DAYS OR LESS! TRY AMAZON PRIME FOR FREE HERE: https://amzn.to/2t4QD6I
In this video I am building a new metal and wood entry gate. I used 16 gauge steal square tubing for the frame, and pressure treated wood for the center.
I applied a matte black finish to the metal, and thompsons water seal to the wood. I used my Hobart handler 140 set up with mig gas (75/25) for all of my welding.
Kinda wish I had my flux core wire in because it was windy at times and I could diffidently tell my gas was being blown away.
I Had the worlds worst opening to fill with my material. Vertically the wall was out an 1.5” from top to bottom. Across the bottom the concrete dipped 2 inches. What a pain it was trying to get all the correct angles. I diffidently stuck with it and gotter done folks (Redneck repair) .
this was diffidently a great project to hone your welding skills.
hope you enjoyed this metalworking woodworking diy project
Till next time ladies and gents….
Don’t forget to rate comment and SUBSCRIBE!!!
Thanks for all the support
Stelios the Greek
GET $30 OFF SELECT TOOLS ON AMAZON BY CLICKING HERE: https://amzn.to/2KWrS3Y
Amazing Woodworking Audio Book: https://amzn.to/2FQVVZY
Download it FREE here: https://amzn.to/2DIrUwF
Awesome Woodworking Plans: https://amzn.to/2I22Sek
Adirondack Plans: https://amzn.to/2IgzQqp
~My Tools~
Chisels: https://amzn.to/2FVRsFf
Sander: https://amzn.to/2FSErwd
Welder: https://amzn.to/2I0YE6v
Miter Saw: https://amzn.to/2FSExE5
Router: https://amzn.to/2ORxRu4
Best Finish: https://amzn.to/2I2ch5G
Clamps: https://amzn.to/2VqgpPR
Best CA Glue: https://amzn.to/2FRmIp8
Square: https://amzn.to/2I5ixJM
Watch all your favorite shows and movies for FREE here: https://amzn.to/2uR7trc
– Some Links Above are Affiliate Links! Thank you for Supporting My Channel! 🙂
Music by Dyalla Swain: Soundcloud.com/dyallas
About The Author
You Might Be Interested In
Comment (0)
LEAVE YOUR COMMENT
You must be logged in to post a comment.
This site uses Akismet to reduce spam. Learn how your comment data is processed.
Nice job Stelios, but Ive spent my working life encouraging people to to wear PPE (personal protective equipment) so they wont hurt themselves at work. Put some shoes on dude (0.45), people look up to you, don't be bad example.
I am confident that the safety flip flop foot wear chosen for the tack welding portion of this job are OSHA approved…….hahahhahahah all kidding aside,,,,,, great job looks good
That was a nice job on the gate. What brand was the grinding wheel you were using.
Bravo! Très intéressant. Je n'ai pas compris comment faire l'emplacement de la serrure. Bonne continuation et merci !!!!
What made you want to use pressure treated wood? also, how you gonna replace the wood panels if ya need or want to being you welded them in?
It pretty obvious you are not no welder….lol
your stick is too far out
05:25
01:45
02:05