In this video I replaced a 80%, 90,000BTU, natural gas hot water boiler made by Slant Fin for the first time. Area was tight but the small boiler, the set up of the controls and return piping on right hand side of unit made it easy.
David helps a NY couple find their second home on Oneida Lake. source
Brian and Mika help an engaged couple with their first big joint decision. source
This home is located in the neighborhood of Rocky Creek in Southwest Austin. The builder…
A family building a dovetail log cabin races to beat the elements. source
In this video, you will learn how to set up a photography studio at home…
View Comments
Great vid - we have the same one -
Nice and clean install. I'm looking at installing the natural gas Slant Fin VHS-90EP. The installation instructions say that circulator pump that it comes with can be utilized with two separate zone control valves, but where I get a little lost is if a zone valve relay like a Taco needs to be used because of two thermostats. I have most of my baseboard heat installed and there will be 2 zones; one for the first floor and one for the second floor. Any help would be appreciated..thanks in advance.
I had both old boiler and heater replaced and so far so good!
PSE&G does replacements and give 12 months free financing. .sweet deal ..
How come you didn’t stay with the 1 1/2 supply it usually comes with is it space constraint only?
Where’s the high limit located?
What’s your homes square footage?
nice installation but only one regret...the boiler is place down the floor you should put it a plywood wood in level it the floor before you put the boiler on the floor the gas line look too down..
How to pipe a slant fin boiler
Thank you for the video
Question
At what place did u make the transition from 1 1/2 to 1 in pipe ?