This video provides step-by-step instructions for using the installation hardware kit to install your dishwasher.
Buy part #WPW10292152 now: https://www.repairclinic.com/PartDetail/1875202?TLSID=1873
Additional dishwasher repair, troubleshooting tips, help with finding your model number and part replacement videos can be found on our website:
http://www.repairclinic.com/RepairHelp/Dishwasher-Repair-Help?TLSID=1873
All of the information for this hardware kit replacement video is applicable to the following brands:
Kenmore, KitchenAid, Whirlpool, Ikea, Amana, Jenn Air, Maytag
Tools needed: 1/4″ nut driver, Channel Lock pliers, phillips head screwdriver
Buy part #S144CB now: https://www.repairclinic.com/PartDetail/3527710?TLSID=1873
Buy part #N140CB now: https://www.repairclinic.com/PartDetail/3527674?TLSID=1873
Buy part #420 now: https://www.repairclinic.com/PartDetail/3527534?TLSID=1873
Connect With Us!
https://plus.google.com/+repairclinic
https://www.facebook.com/RepairClinic
https://www.twitter.com/RepairClinic
http://pinterest.com/RepairClinic/
Join our free VIP email list for discounts and money-saving tips: http://tinyurl.com/pnnh3be
Check out our blog: http://www.DIY.RepairClinic.com
Don’t forget to like and comment on this video, and subscribe to our channel!
David helps a NY couple find their second home on Oneida Lake. source
Brian and Mika help an engaged couple with their first big joint decision. source
This home is located in the neighborhood of Rocky Creek in Southwest Austin. The builder…
A family building a dovetail log cabin races to beat the elements. source
In this video, you will learn how to set up a photography studio at home…
View Comments
Nice helpful video, although I would add to test and confirm the power is off at the wiring before disconnecting / handling the wiring. I've been to multiple situations where the breaker was either labeled wrong or didn't work properly and then the wiring remained hot /on.
You show how to drill pilot holes for side mount screws and then show the screws going into the under the counter mount???
I was doing a side mount, and could not figure out how the bracket was supposed to work, it kept falling down,a nd I had to keep fishing it out, and pulling the dishwasher out multiple times, nowhere did it say to bend the bracket to get it to not fall out, this was the trick! thanks for the video.