Categories: Plumbing and insulation

GAS FIREPLACE EASY INSTALL (How to run your gas line!)

GAS FIREPLACE EASY INSTALL (How to run your gas line!)
This is a quick walk through of how to run a gas line to your gas fireplace. Note: ALL gas should be turn off when replacing any valve on main line. My plumber left me a valve to tie into, so I just built off that, also make sure your fireplace is full installed before running gas line. Thanks for watching like and subscribe.
Amazon Affiliate.

PARTS LIST BELOW:

LINK TO FIREPLACE:
http://amzn.to/2BNJBqZ
LINK TO GAS LINE:
http://amzn.to/2zcT7RI
BRASS MALE FITTING:
http://amzn.to/2zdrQyi
BRASS FEMALE FITTING:
http://amzn.to/2BQkzaw
GAS VALVE:
http://amzn.to/2BOXuoZ
GAS LINE CUTTER:
http://amzn.to/2BYAmXo
YELLOW GAS LINE TAPE
http://amzn.to/2DvnMgs

#fireplaceinstall, #gaslineinstall, #diythisguy

Daniel Miller

Next 3 Easy DIY Projects You Can Make In One Day - Woodworking »

Previous « CUSTOMIZE YOUR IKEA FURNITURE | DIY Hack with Vinyl Wrap

View Comments

anomalyjustin says:

27/02/2019 at 19:31

Dude, you stripped off WAY too much of the yellow jacket, and you didn't bond any of it to prevent explosion during a lightning strike.
Shah Ali says:

05/03/2019 at 05:42

Thank you for sharing great tips
Bd K says:

29/05/2019 at 02:08

Not sure which one of the several codes you broke to comment on. Too hard to pick just one
Richard Landrum says:

03/09/2019 at 19:44

Installing a gas log set or fireplace is NOT a DIY project. It must be installed by a Certified Gas Technician. Do it your self and have a problem that damages your home and you Home Owner's Insurance won't know you!
The Gasman says:

18/10/2019 at 00:16

Ran across this so wrong it's funny
Please don't look to this for help
Gas shutoff has to be in same room within 6 foot of appliances flex connector you have hooked to fireplace cannot pass through floors or walls not sure but looks like you screwed 1/2" pipe coupling in between valves onto a flare fitting no coragations on cast should be showing stripped way to much back can do it but have to tape with silicone tape don't need drip leg on fireplace just unattended appliances such as water heater furnace not required on range or dryer or fireplace and drilled though bottom of fireplace it has holes on sides of bottom for line to pass though it's fine you did it but please don't encourage others
Retros 4Life 79Boxing says:

08/11/2019 at 00:17

The idiots that previously owned my home put in a gas powered fireplace that runs outside to a small propane tank. The line runs weird to the tank that's definitely not professional.
JonBeeTheProducer says:

12/11/2019 at 01:39

Wow 3 shut off valves. Also that line in made to bend. It’s corrugated stainless steel, it is incredibly hard to kink, that small amount is not messing up the flow of gas at all.
Azael Estefania says:

12/11/2019 at 19:07

Goofy job...
Punx Not Dead says:

08/12/2019 at 18:48

Thanks, as far as a gas fireplace, i got tubing running from gas line into a pilot kit which seem.j s close to open flames like most are, is that safe? Metal rated for flame temps, thanx
Robon2ndShift says:

15/05/2020 at 17:08

Good video on how not to do this job. I bet you shingle from the top down too.